A pipeline is a sequence of one or more commands separated by one of the control operators | or |&. The
format for a pipeline is:
[time [-p]] [ ! ] command [ [|⎪|&] command2 ... ]
The standard output of command is connected via a pipe to the standard input of command2. This
connection is performed before any redirections specified by the command (see REDIRECTION below). If |&
is used, the standard error of command is connected to command2's standard input through the pipe; it is
shorthand for 2>&1|. This implicit redirection of the standard error is performed after any
redirections specified by the command.
The return status of a pipeline is the exit status of the last command, unless the pipefail option is
enabled. If pipefail is enabled, the pipeline's return status is the value of the last (rightmost)
command to exit with a non-zero status, or zero if all commands exit successfully. If the reserved word
! precedes a pipeline, the exit status of that pipeline is the logical negation of the exit status as
described above. The shell waits for all commands in the pipeline to terminate before returning a value.
If the time reserved word precedes a pipeline, the elapsed as well as user and system time consumed by
its execution are reported when the pipeline terminates. The -p option changes the output format to that
specified by POSIX. When the shell is in posixmode, it does not recognize time as a reserved word if
the next token begins with a `-'. The TIMEFORMAT variable may be set to a format string that specifies
how the timing information should be displayed; see the description of TIMEFORMAT under ShellVariables
When the shell is in posixmode, time may be followed by a newline. In this case, the shell displays the
total user and system time consumed by the shell and its children. The TIMEFORMAT variable may be used
to specify the format of the time information.
Each command in a pipeline is executed as a separate process (i.e., in a subshell).
compress or expand files
a block-sorting file compressor, v1.0.6
manipulate tape archives
adds all files from directory "dir1" to archive archive.7z using "ultra settings"
-t7z 7z archive
-mx=9 level of compression = 9 (Ultra)
number of fast bytes for LZMA = 64
dictionary size = 32 megabytes
-ms=on solid archive = on
add all files from directory "dir1" to SFX archive archive.exe (Remark : SFX archive MUST end with
add all files from directory "a_directory" to the archive "archive.7z" (with data and header
archive encryption on)